Using the refrigerator CD0050, CRD1050
16
I
Proceed as follows when you connect the refrigerator to the AC supply:
➤ Fix the rectifier as shown in the location foreseen, behind the refrigerator (fig. 9,
page 5).
➤ Protect the AC circuit using a slow-blow fuse (250 V/4 A).
➤ Connect the power cable to the AC power supply.
➤ Plug in the connecting cable to the AC socket (fig. 9 1,page 5).
Proceed as follows when you connect the refrigerator to a DC supply when a rectifier
is fitted:
➤ Connect the loose DC cable (fig. 9 2, page 5) to the battery:
– Red cable: positive battery terminal
– Black cable: negative battery terminal
8 Using the refrigerator
I
8.1 Energy saving tips
•
Choose a well ventilated installation location which is protected against direct
sunlight.
•
Allow warm food to cool down first before placing it in the cooling device to
keep cool.
•
Do not open the cooling device more often than necessary.
•
Do not leave the cooling device open for longer than necessary.
NOTE
Always connect the refrigerator to the rectifier. Otherwise the priority
circuit for the refrigerator will be disabled.
The priority circuit reduces the load on a connected battery by the
rectifier always switching to mains operation if AC power is connected.
NOTE
Before starting your new refrigerator for the first time, you should clean
it inside and outside with a damp cloth for hygienic reasons (please also
refer to the chapter “Cleaning and care” on page 20).
CD0050-CRD1050-O-EN-FR.book Seite 16 Dienstag, 10. Oktober 2017 11:13 11
To Next Page
Loading...
Need help?
General
