EN
CFX3 Operation
31
Removing the ice maker housing
The ice maker housing can be removed for cleaning or when not in use to increase
usable space inside the cooler:
➤ Lift the housing at one end until the lug unclips, then remove.
➤ Reverse procedure for re-fit, pushing down on lugs to snap into position.
Tips for using the ice maker
• The ice maker makes ice fast for a number of hours after switching on and then
automatically goes into an ice maintenance mode to reduce energy
consumption. If multiple batches of ice are required as quickly as possible,
switching the ice maker off and back on will set it back into fast ice making mode.
Repeat as required.
• Low freezer temperature settings in the main compartment may not be main-
tained in high ambient conditions with the ice maker switched on.
Cleaning and drying the ice maker
➤ When not in use clean and dry the ice trays and inside the ice maker housing to
prevent mould.
➤ Following extended periods of non-use clean the inside of the ice trays with a
mild dish washing solution and rinse with clean water prior to use.
7.14 Downloading the CFX3 app
The cooler can be monitored and controlled via Bluetooth or WiFi using an app that
you can install on a compatible device.
➤ Download the CFX3 app from App Store or Google Play.
Note that the CFX3 app may not be available in your country.
'RPHWLF&);B230BB$3$&HQB[[[[[ERRN6HLWH0LWWZRFK6HSWHPEHU
To Next Page
Loading...
Need help?
General