DC-Kit2 Technical description
13
6 Technical description
The DC-Kit2 extension kit enables Dometic roof air conditioners to be used in
vehicles with 12 Vg. The extension kit consists of the following components:
• The ECL-102 charging current distributor with low voltage protection regulates
the power distribution between the starter battery, supply battery and light-
machine. This prevents the battery and the electronics in the vehicle from over-
loading.
• The PP2002 inverter supplies the roof air conditioner with the required input
voltage of 230 Vw. The inverter generates the 230 V input voltage from the 12 V
on-board electricity supply in the vehicle.
Remote control RC1 can switch the inverter on and off (applies to CA2500/
B2200/B1600 Plus, FJ1100/FJ1700/ FJ2200/FL1600/FL2200).
The integrated priority circuit can be used for distributing the voltage in the
vehicle with two available power sources. If a mains voltage and voltage created
by the inverter (vehicle battery) are both connected to the device, the use of the
mains voltage has priority. If the only voltage available is that generated by the
inverter, the power supply from the battery is used. This ensures that the limited
power of the battery is not used unnecessarily.
• B1600: The RC2 remote control can switch the inverter on and off.
• The inverter adapter ensures that the condenser fan for the roof air conditioner
can control the speed.
DC-Kit2--IO-16s.book Seite 13 Dienstag, 21. März 2017 2:15 14
To Next Page
Loading...
Need help?
General
