DM50C Troubleshooting
17
8 Troubleshooting
9 Cleaning and maintenance
!
A
➤ Occasionally clean the device interior and exterior with a damp cloth.
Fault Possible cause Suggested remedy
Device does not
function, Status LED
does not glow.
No voltage present in
the AC voltage socket.
Try using another plug socket.
The mains adapter is
defective.
This can only be repaired by an
authorised repair centre.
The device does not
cool (plug is inserted,
Status LED glows).
Defective compressor This can only be repaired by an
authorised repair centre.
The Error LED flashes
once per second.
Temperature sensor is
defective.
This can only be repaired by an
authorised repair centre.
Device does not cool
sufficiently, Status LED
glows, Error LED does
not glow.
Defective compressor This can only be repaired by an
authorised repair centre.
Poor ventilation Check the ventilation.
Clean the filter underneath the device.
WARNING!
Always disconnect the device from the power supply before you clean
and service it.
NOTICE! Risk of damage
• Never clean the cooler under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooler.
DM50C-MB--AUS--EN.book Seite 17 Donnerstag, 1. September 2016 9:08 21
To Next Page
Loading...
Need help?
General
