- 9 -
To mount the handles, follow these steps:
Snap on the handle by inserting its tabs in the slot 1.
and slide into place.
The refrigerator is equipped with hinges that makes it possible
to change the direction the door opens by moving the hinges
pins to the opposite side. For additional information, please
contact service point or distributor service dept. for assistance.
The refrigerator is delivered without door panels. Before start-
ing the mounting work, read this instruction thoroughly and
check that the panel dimensions are in compliance with those
given in the table below.
upper
inch
16,57 16,5 23,7 23,6
mm
421 419 602 600
lower
inch
34,68 34,61 23,7 23,6
mm
881 879 602 600
inch
16,57 16,5 23,74 23,66
mm
421 419 603 601
lower
inch
34,68 34,61 23,74 23,66
mm
881 879 603 601
To install the door panel, follow these steps:
Remove the decoration strip by inserting a finger in 1.
the plastic profile and pull.
To Next Page
Loading...
Need help?
General
