No. in fig.
Description
1 USB port for power supply
2 Connection cable for DC connection
3 Ventilation slots
4 Handle
Operation
NOTICE! Risk of damage
Ensure that the objects placed in the cooling device are suitable for cooling to the selected temperature.
Ensure that food or liquids in glass containers are not excessively refrigerated. Liquids expand when they freeze and can therefore destroy the glass
containers.
Ensure that your cooling device is well ventilated so that any heat created can dissipate. Otherwise proper functioning cannot be ensured. It is
especially important not to cover the air vents.
NOTE
Before starting your new cooling device for the first time, you should clean it inside and outside with a damp cloth for hygienic reasons (please also
refer to the chapter “Cleaning and maintenance” on page 10).
A few water drops may form inside the cooling device if it has been cooling for a lengthy period. This is normal because the moisture in the air
condenses to water when the temperature in the cooling device falls. The cooling device is not defective. Wipe it out with a dry cloth if necessary.
If the handle is folded back or if the cooling device is being carried, the lid is locked. You can only open the lid when the handle is folded forwards.
Saving energy
Choose a well ventilated location which is protected from direct sunlight.
Allow warm food to cool down first before placing it in the cooling device to keep cool.
Do not open the cooling device more often than necessary.
Do not leave the cooling device open for longer than necessary.
If the cooler has a basket: For optimal energy consumption, position the basket according to its position on delivery.
On a regularly basis, make sure the lid seal still fits properly
Using the cooling device
NOTE
If you connect the cooling device to the cigarette lighter of your vehicle, remember that the ignition must be
turned on to supply it with power.
1. Place the device on a firm base.
2. Connect the 12 V/24 V DC connection cable (fig. ) to the cigarette lighter or the DC socket in the vehicle
✔ The device starts cooling the interior.
➤ To switch off the cooling device, disconnect the DC connection cable.
USB port for power supply
The USB port (fig. ) allows you to charge small devices like mobile
phones and mp3-players.
Using the USB port does not affect the cooling performance.
NOTICE!
Ensure that any device connected to the USB port is compatible with 5 V/500 mA operation.
Proceed as follows (fig. ):
1. Connect the 12 V/24 V DC connection cable ( 2) of the cooling device with the power supply.
2. Connect your device to the USB port ( 1).
To Next Page
Loading...
Need help?
General
