To Next PageTo Next PageTo Previous PageTo Previous Page
What to do if the Dräger Safety Equipment test failed?
If the Dräger Safety Equipment displays 'Test failed', it means the measured breath alcohol concentration is above the set limit. Wait at least 15 minutes and repeat the test. If the message appears again, the breath alcohol concentration is still above the limit value.
How to fix Dräger Safety Equipment when it says 'Check cable and reconnect'?
If the Dräger Safety Equipment displays 'Check cable and reconnect!', it means there is no connection between the handset and control unit. Check the plugs of the connecting cable and reconnect them to the handset and control unit. If the error message reappears, further assistance is needed.
What does 'Handset error' mean on Dräger Safety Equipment?
If the Dräger Safety Equipment displays 'Handset error', it indicates a fault on the handset. Try switching the ignition off and on, then repeat the test. If the error message reappears, further assistance is needed.
Why is there no display message on my Dräger Safety Equipment handset?
If there is no display message on the Dräger Safety Equipment handset, it indicates no connection between the handset and control unit. Check the connecting cable plugs, disconnect the plug from the handset, and reconnect it. If no messages are still shown, further assistance is needed.
What to do if Dräger Safety Equipment shows 'Control unit error'?
If the Dräger Safety Equipment displays 'Control unit error', it indicates an error in the control unit. Try switching the ignition off and on, then repeat the test. If the error message reappears, further assistance is needed.
How to fix 'Low Temperature' error on Dräger Safety Equipment?
If the Dräger Safety Equipment displays 'Low Temperature', it means the handset temperature is too low. Detach the handset and take it to a place with a moderate temperature. Connect the handset again and perform the test.
What to do if Dräger Safety Equipment displays 'High Temperature'?
If the Dräger Safety Equipment displays 'High Temperature', it means the handset temperature is too high. Detach the handset and take it to a place with a moderate temperature. Connect the handset again and perform the test.
What does 'Please retry' mean on Dräger Safety Equipment?
If the Dräger Safety Equipment displays 'Please retry', it means a fault was detected during the delivery of the breath sample. Deliver the breath sample again when requested by the instrument.
How to fix 'Blow harder' on Dräger Safety Equipment?
If the Dräger Safety Equipment displays 'Blow harder!', it means the breath sample was blown too softly. Repeat the test, blowing harder this time.
General| Data Logging | Yes |
|---|---|
| Device Type | Alcohol Tester |
| Technology | Electrochemical |
| Measurement Principle | Electrochemical |
| Response Time | < 5 seconds |
| Humidity Range | 10 to 95 %RH, non-condensing |
| Power Supply | Rechargeable battery |
| Display | LCD |
| Alarm | Audible and visual |
General safety statements and precautions for using the Dräger Interlock product.
Detailed explanation of how the Dräger Interlock 5000/7000 operates and its features.
Defines the primary purpose of the Dräger Interlock 5000/7000 as a breath alcohol measuring instrument.
Instructions and warnings related to the installation of the Dräger Interlock system.
Step-by-step guide on how to perform a breath alcohol measurement.
Troubleshooting common display errors and their potential causes.
Resolving issues related to breath sample quality and delivery during measurements.
Addressing errors like 'Test failed', low/high temperatures, or service requirements.
Information on calibration procedures, frequency, and service interval notifications.
Adjustable settings for test results display, breath test volume, and restart period.
