Vigor2912 Series User’s Guide
323
click Disable to close the mechanism of notification.
STUN Settings
The default is Disable. If you click Enable, please type the
relational settings listed below:
Server IP – Type the IP address of the STUN server.
Server Port – Type the port number of the STUN server.
Minimum Keep Alive Period – If STUN is enabled, the
CPE must send binding request to the server for the purpose
of maintaining the binding in the Gateway. Please type a
number as the minimum period. The default setting is “60
seconds”.
Maximum Keep Alive Period – If STUN is enabled, the
CPE must send binding request to the server for the purpose
of maintaining the binding in the Gateway. Please type a
number as the maximum period. A value of “-1” indicates
that no maximum period is specified.
After finishing all the settings here, please click OK to save the configuration.
4
4
.
.
1
1
4
4
.
.
3
3
A
A
d
d
m
m
i
i
n
n
i
i
s
s
t
t
r
r
a
a
t
t
o
o
r
r
P
P
a
a
s
s
s
s
w
w
o
o
r
r
d
d
This page allows you to set new password.
Available settings are explained as follows:
Item Description
Old Password
Type in the old password. The factory default setting for
password is “admin”.
New Password
Type in new password in this field. The length of the
password is limited to 23 characters.
Confirm Password
Type in the new password again.
When you click OK, the login window will appear. Please use the new password to access
into the web user interface again.
To Next Page
Loading...
Need help?
General
