22
EN
Troubleshooting
If the vacuum is not working properly, the screen display will show an error message. Please
refer to the troubleshooting table to find your solution.
Error Icon Status Error Message Solutions
Blinking Red
High-temperature
Alert
Please wait and continue to use after
motor temperature is normal.
Blinking Orange Roller brush stuck
Refer to the maintenance guide
[Cleaning the Smart Multi-Surface
Brush] section to clean the fiber
material and hairs wrapped around the
brush roller.
Blinking Orange Air Duct Blocked
Check whether the dust cup, carbon
fiber rod, and smart multi-surface
brush are blocked.
Blinking Orange Filter is expiring
Please replace the filter in time. After
replacing the filter, press and hold the
trigger switch lock for 3 seconds to
reset the filter.
Solid Orange Filter uninstalled
Ensure that the filter and pre-filter are
installed correctly.
Solid Red Error
Please contact the after-sales
department for maintenance.
If one of the error codes from E0 to E4 appears on the display, please contact the after-sales
service team for repair.
To Next Page
Loading...
Need help?
General
