Label each
Z
o
n
e
Enter Keypad Programming be entering *8-5555 and then press (*) NOTE: Make sure
the keypad says Enter LCD Section before trying to label your zones. You will
need to enter each zone (001) edit label, (002) edit label, etc. The letters of the alphabet
are divided up among the number keys 1-9 on the keypad as described:
[1] A B C 1 [2] D E F 2 [3] G H I 3
[4] J K L 4
[5] M N O 5
[6] P Q R 6
[7] S T U 7
[8] V W X 8
[9] Y Z 9 0
[0] SPACE
[*] SELECT
[#] ESCAP
“*” is to select and save
You select the letter you want by continuously pressing the same button until your
desired letter or number appears. Then you can you the left and right arrows to move
to the next location or simply press the next number which corresponds to your next
character.
Making a DSC Alexor/Impassa call your phone
You will want to enter programming by entering:
* 8 5 5 5 5, enter program section 301 and then enter the telephone number for the system
to call (Make sure the “D” remains and make sure to include the area code, if needed from
that number). (Note: The panel should read D1234567890EEEEEEEE..), hit # one time.
Enter Section 320 and enter (11 sixteen times) 11 11 11 11 11 11 11 11 11 11 11 11 11 11
11 11 and then the system will beep 3 times.
Enter section 350 and enter 06 06 06 06, system will beep 3 times
Enter section 310 and enter 1 2 3 4 * 6 6 (the 6's will be F's), system will beep 3 times
Now hit # # #
NOTE: When the system calls your phone, you must give it a handshake. This is simply
done by pressing a: 1, 2, 4, 5, 7, 8, 0, * or #. When the noise on the phone turns into an
alarm tone, and then it accepted the handshake.
http://alarmsystemstore.com
http://alarmsystemstore.com
To Previous Page
Loading...
Need help?
General
