DSC PowerSeries Neo HS2016-4 User Guide

Chapter 4.0 Setting the Alarm System
1. Away Set
2. Stay Set
3. Unset
4. Panic
5. Command Output 1
6. Message LED
7. Status LEDs
1. Away Set
2. Stay Set
3. Unset
4. Panic
5. Command Output 1
6. LED
Note: Panic feature has not been evaluated by UL. All wireless key buttons are programmable.
Verify the functions assigned to each key with your installer. When using compatible wireless keys
there is one bell squawk for setting and two bell squawks for unsetting.
4.6.1 Setting the System with a 2-Way Wireless Key
If configured, the PowerSeries Neo system can be set using the following wireless keys:
l PG4929/PG8929/PG9929
l PG4939/PG8939/PG9939
To Set the System with a 2-way wireless key
l Press the desired Setting mode button anytime the system Ready indicator is on.
4.6.2 Setting the System with a Proximity Tag
Depending on how your keypad is programmed, proximity tags can be used to either set/unset the
system or to perform a programmed function (e.g. unlock a cabinet or storeroom door).
To Set the System with a Proximity tag
l Present your Proximity tag to a keypad equipped with a proximity sensor anytime the sys-
tem Ready indicator is on.
l If configured by your installer, enter your access code.
Note: When using a proximity tag and a Stay/Away zone is programmed, the system sets in Away
mode if a delay zone is tripped. If there is no Stay/Away zone, the system always sets in Away
mode.
4.7 Alarm System Unsetting Methods
The PowerSeries Neo system is capable of supporting the following alarm system unsetting methods
in accordance with BS8243-2010
l Prevention of entry to the supervised premises before the partition is unset.
l Unset by using the wireless key before entering the supervised premises causes or permits
the initial entry door to be unlocked.
l
Unset by using the Mini Prox tag in conjunction with one of the keypad modules
HS2LCDP, HS2ICNP, HS2LCDRFP8, or HS2ICNRFP8, after entering the supervised
premises and within the programmed entry delay.
4.7.1 Unsetting the System
Depending on your system configuration, there are multiple methods you can use to unset your sys-
tem. You can unset the system using a 2-way wireless key or a proximity tag:
To Unset the System with a 2-way Wireless Key
1. Press the unset button anytime the system is set. ( Set indicator is on).
2. If you walk through the entry door the keypad will beep. Press the unset button within ____
seconds to avoid an alarm condition.
- 10 -

DSC PowerSeries Neo HS2016-4 Specifications

General

Brand	DSC
Model	PowerSeries Neo HS2016-4
Category	Security System
Language	English