34
. Pure Dark Image “Top Margin” Adjustment
Pure dark image on whole image such as black, grey, grey, green blue…etc without 0.5” white
boundary will causing top margin cutting variance due to sensitivity differential. Recommend to do
“Top Margin” calibration.
The calibration allows calibrate procedure as below:
On job #4 to hold then tip on to set cutting mark, cut a printed sheet with mark, make sure
the leading edge of the mark to cutting line is 3mm
Select mark:50, if the cut mark leading edge to cutting line is greater or smaller than 3mm, tip on
and to adjust. Each press represents 0.1mm increment or decrement.
After adjust the mark value, press to save the setting. Cut the mark again, if the cut mark is not
within spec. repeat the calibration.
To Next Page
Loading...
Need help?
General
