17
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
11. TROUBLE SHOOTING GUIDE
Heater ignites but MAIN PCB 1. Wrong pump pressure 1. See Pump Pressure Adjustment,
assembly shuts heater off after page 16.
a short period of time. 2. Dirty Air Output, Air Intake 2. See Air Output, Air intake
(Lamp is flickering) and Lint Filter and Lint Filters, page 11.
3. Dirty Fuel Filter 3. See Fuel Filter, page 14.
4. Dirt in Nozzle 4. See Nozzle, page 12.
5. Dirty Photocell Lens 5. Clean Photocell Lens, page 13.
6. Photocell Assembly not 6. Make sure photocell boot is
properly installed. (Not properly seated in bracket,
seeing the flame) page 13.
7. Bad electrical connection 7. Check electrical components
between photocell and MAIN See wiring diagram, page 18.
PCB assembly
8. Defective photocell 8. Replace photocell, page 13.
Heater will not ignite but 1. No fuel in tank 1. Fill tank with kerosene
motor runs for a short period 2. Wrong pump pressure 2. See Pump Pressure Adjustment,
of time. (Lamp is flickering) page 16.
3. Carbon deposits on spark 3. See Spark Plug, page 13.
plug and/or improper gap
4. Dirty fuel filter 4. See Fuel Filter, page 14.
5. Dirt in nozzle 5. See Nozzle, page 12.
6. Water in fuel tank 6. Flush fuel tank with clean
kerosene, page 10.
7. Bad electrical connection 7. Check electrical connections,
between ignitor and MAIN See wiring diagram, page 18.
PCB assembly
8. Ignitor wire is not attached to 8. Attach ignitor wire to spark
spark plug plug. See Spark Plug, page 13.
9. Defective ignitor 9. Replace ignitor.
Fan does not turn when heater 1. Thermostat setting is too 1. Turn thermostat control knob
is plugged in and power switch low to a higher setting
was in the “ON” position 2. Bad electrical connection 2. Check electrical connections,
(Lamp is on or flickering) between motor and MAIN See Wiring Diagram, page 18.
PCB assembly
1. Temperature limit safety 1. Turn power switch to “OFF”
device is overheated and allow to cool (about 10 min.).
Then turn power switch to
Heater will not turn-on “ON” position.
(Lamp is off) 2. No electrical power 2. Check to insure heater cord and
extension cord are plugged in.
Check power supply.
3. Blown fuse 3. Replace safety fuse in PCB board.
4. Bad electrical connection between 4. Check electrical connections.
temperature limit safety device See Wiring Diagram, page 18.
and PCB board
TROUBLE POSSIBLE CAUSE CORRECTIVE ACTION
To Next Page
Loading...
Need help?
General
