Dynacraft My Little Pony User Manual

6
FOLDING YOUR SCOOTER
A. Pull the locking lever upward to release the lockring mechanism.
B. While lifting the lever, begin lowering the front end of the scooter.
C. Release the lever and fold the front end back and parallel with the wheel
section of the scooter until you hear a “click” sound. This means the
scooter is folded securely and may be picked up and transported.
NOTE: After use, there should be clearance after the front end of the scooter
has been locked into the upright position, you may use a 2.5mm Allen key to
adjust tightness through two holes in the front protective metal cover. (see
image below)
STEP 2: HANDLEBAR PLACEMENT
The handlebars are held in place by spring loaded buttons.
TO INSTALL HANDLEBARS:
A. Position the handlebars so that the
button is aligned with the hole located
on top of the steering tube.
B. While pressing the button, push the
handlebar end into the steering tube
until the button “clicks” into the hole of
the steering tube.
WARNING
Failure to properly tighten the steering height adjustment clamp can result
in improper handlebar movement and loss of steering control.
Two holes in
protective
metal cover
POP BUTTON
STEERING TUBE
HANDLEBAR END HOLE

Dynacraft My Little Pony Specifications

General

Brand	Dynacraft
Model	My Little Pony
Category	Scooter
Language	English