EarthQuake CS4518 User Manual

Page 17
Before you start the engine, make sure the saw chain is not
contacting anything.
STARTING ENGINE
1. Untwist and remove the fuel cap. Rest the cap on a dustless place..
2. Put fuel into the fuel tank to 80% of the full capacity.
3. Fasten the fuel cap securely and wipe up any fuel spillage
around the unit.
4. Put the switch to the "I" position.
5. Continuously push the priming bulb until fuel comes in the bulb.
(1) Oil
(2) Fuel
(3) Engine switch
(4) Choke knob
6. Pull out the choke knob. The choke will close and the throttle lever
will then be set in the starting position.
NOTE
When restarting immediately after stopping the engine.
Set choke in the open position
NOTE
Once the choke knob has been pulled out, it will not return to the
operating position fully even if you press down on it with your finger.
When you wish to return the choke knob to the fully open position,
squeeze the throttle lever instead.
7. While holding the saw unit securely on the ground, pull the
starter rope vigorously.
Operation
WARNING

EarthQuake CS4518 Specifications

General

Brand	EarthQuake
Model	CS4518
Category	Chainsaw
Language	English