25EATON 620 Mobile Open Circuit Piston Pump Service Manual E-PUPI-TS018-E2 November 2017
Disassembly
6. Remove bearing race from end cover
7. Remove crush ring (if required)
Note: The Crush Ring located under the bearing cup in the
end cover does not need to be removed. The only time the
crush ring needs to be removed is when the front or rear
shaft tapered roller bearings, bearing cups, drive shaft, end
cover or housing assembly is replaced. A shim kit is required
if the crush ring is replaced.
9. Remove gasket
8. Remove bearing from shaft
To Next Page
Loading...
Need help?
General
