Eaton 9E15Ki User Manual

31
Connectivity Cards
The UPS is equipped with an expansion slot for optional Connectivity
Cards (see figure on right).
It is not necessary to shutdown the UPS before installing a communication
card.
1. Remove the slot cover secured by screws.
2. Insert the communication card in the slot.
3. Secure the card cover with the 2 screws
Connectivity cards allow the UPS to communicate in a variety of
networking environments and with different types of devices.
• Network-MS card - has SNMP and HTTP capabilities as well as
monitoring through a Web browser interface; connects to Ethernet
network. In addition, a Environmental Monitoring Probe can be atta-
ched to obtain humidity, temperature, smoke alarm, and security
information.
• Modbus-MS card - has connection to Modbus protocol in addition to
network management.
• Relay-MS card - has isolated dry contact (Form-C) relay outputs for
UPS status: Utility failure, Battery low, UPS alarm/OK, or on Bypass.
4.3.3 Eaton Intelligent Power Software suite

Eaton 9E15Ki Specifications

General

Output Power Factor	0.9
Topology	Double Conversion Online
Output Frequency	50/60 Hz
Form Factor	Tower
Power Rating	15 kVA
Input Voltage	220-240 V / 380-415 V (3:1)
Output Voltage	220-240 V / 380-415 V (3:3)
Battery Type	Sealed lead-acid (VRLA)
Runtime at Full Load	5 minutes
Communication	RS-232, USB
Expandability	External battery packs