11
OPERATION
WHEN
THE ENGINE IS COLD
WARNING
Make sure bar and chain are not touching anything when
starting the saw.
1. Move chain brake lever fully forward to engage chain
brake before starting.
2. Fill the fuel tank with fuel. Do not over fill.
3. Fill the chain oil tank with lubricant. Do not over fill.
4. Turn switch (A) to “RUN” position (I).
5. Pull choke (B) all the way out (closed position).
6. Push purge bulb (C) 10 times.
7. Pull starter handle several times until first firing sound is
heard. (Secure unit on ground with your knee or foot.) (5
- 6 pulls maximum.)
8. Push choke (B) all the way in (open position)
9. Pull starter handle again.
NOTE
If engine does not start after 5 pulls, repeat instructions.
WARNING
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from
all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a com-
plete stop before removing obstructions, clearing debris, or servicing unit.
WARNING
Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a poison gas. Breathing CO can cause uncon-
sciousness, serious injury, or death. Exhaust can cause serious burns. ALWAYS position unit so that exhaust is
directed away from your face and body.
Securely hold the saw.
B
C
A
WARNING
Operation of this equipment may create sparks that can start fires around dry vegetation. This unit is equipped
with a spark arrestor and a spark arrestor may be required. The operator should contact local fire agencies for
laws or regulations relating to fire prevention requirements.
To Next Page
Loading...
Need help?
General