13
A
RUNNING
WARNING
The saw chain should not move at idle, otherwise serious
personal injury may result.
NOTE
If saw chain moves adjust carburetor according to “Carbu-
retor Adjustment” instructions in this manual, or see your
dealer.
• After engine starts, allow it to return to idle.
• Move chain brake lever fully rearward to release chain
brake.
• Press throttle control lockout then gradually squeeze
throttle trigger to increase engine speed.
• Saw chain starts moving when the engine reaches approxi-
mately 4200 rpm.
• Ensure proper acceleration and lubrication of chain and
bar.
• Do not run the engine at high speed unnecessarily.
• Be sure that saw chain stops moving when throttle trigger is
released.
STOPPING
1. Release throttle trigger and turn switch (A) to STOP (O)
position.
2. Move chain brake lever fully forward to engage chain.
NOTE
If engine does not stop, pull choke out fully to stop engine.
Return the unit to your authorized ECHO dealer to check
and repair stop switch before starting the engine again.
To Next Page
Loading...
Need help?
General