10
1. SPARK PLUG - Provides spark to ignite fuel mixture.
2. IGNITION SWITCH - "TOGGLE SWITCH" mounted on side of handle. Move switch up to start and run. Move
down to stop.
3. MUFFLER/SPARK ARRESTOR - The spark arrestor muffler controls the exhaust noise while the spark arrestor
prevents hot, glowing particles of carbon from leaving the muffler.
4. FUEL TANK CAP - Covers and seals fuel tank.
5. CHOKE LEVER - Lever is located on right side of the air cleaner. Move lever DOWN to close choke (starting
position) and for emergency stopping. Move UP to open choke (run position).
6. AIR CLEANER - Contains replaceable felt element.
7. THROTTLE POSITION KNOB - Squeeze throttle trigger and turn knob counter clockwise to hold throttle trigger
open. Squeeze throttle trigger again to return to idle speed.
8. THROTTLE TRIGGER - Spring loaded to return to idle when released if throttle position knob is not engaged.
9. BLOWER PIPES - Twist lock design.
10. STARTER HANDLE - Pull handle slowly until starter engages, then return handle slowly. DO NOT let handle snap
back or damage to unit will occur.
11. PRIMER BULB - Pumping primer bulb before starting engine draws fresh fuel from the fuel tank priming the carbure-
tor for starting. Pump primer bulb until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an
additional 4 or 5 times.
To Next Page
Loading...
Need help?
General
