GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
25
2. Close Choke - Cold Start.
Move choke lever (B) to Cold Start Position.
3. Primer - Pump Bulb.
Pump primer bulb (C) 10 times until fuel is visible in the “Clear” fuel
return line (D).
4. Start - Pull Rope.
Lay the trimmer on a flat clear area and pull the recoil starter handle
(E) until engine fires.
5. Open Choke - Run.
Move the choke lever to the OPEN - RUN position. Restart engine
if necessary and allow to warm up running at idle for several
minutes.
STARTING WARM ENGINE
The starting procedure is the same as Cold Start except DO NOT close
the choke.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
WARNING DANGER
When engine starts, the cutting attachment may rotate even with
the throttle trigger in idle (released) position.
1. Stop Switch - Start/Run. Move stop switch button (A) away from
the STOP position.
B
E
A
C
D
To Next Page
Loading...
Need help?
General