GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
15
2. Position front handle for comfortable operation and secure screws.
U-HANDLE INSTALLATION
Tools Required: 8mm x 10mm Open End Wrench, Screwdriver.
Parts Required: U-Handle Kit P/N 35130455830.
1. Close choke and remove air filter cover.
2. Disconnect two (2) ignition stop leads (C).
3. Remove inner throttle linkage from carburetor swivel (B).
4. Loosen nut (A) and remove throttle linkage from bracket.
5. Loosen screws (D) and remove center shaft location bolt (E).
6. Loosen two (2) rear handle screws (F) and pull rear handle (G) from
the drive shaft assembly.
7. Loosen screw and pull harness clamp (H) from drive shaft
assembly.
8. Loosen four (4) screws and remove front handle (J).
9. Position lower U-Handle Bracket (K) 400mm (15-3/4 in.) from
engine end of drive shaft. Secure with three (3) 5mm x 30mm bolts.
10. Position harness hook 220mm (8-5/8 in.) from engine end of
drive shaft assembly. DO NOT tighten at this time.
A
B
C
D
F
H
G
D
E
400 mm (15-3/4 in.)
220 mm
(8-5/8 in.)
ENGINE
END
K
J
H
To Next Page
Loading...
Need help?
General
