GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
25
3. Use the wooden stick or brush to remove dirt from the cylinder
fins.
4. Remove grass and leaves from the grid between the recoil starter
and fuel tank.
EXHAUST SYSTEM
Spark Arrestor Screen
Level 2.
Tools Required: Cross Head Screwdriver. Scrench. Soft metal brush.
Wooden carbon scraper. 3mm and 4mm Hex Wrench.
Parts Required: Screen P/N 14590555730
Lid Gasket P/N 14586655730
1. Remove three (3) screws retaining muffler cover (B).
2. Place piston at Top Dead Center (TDC) to prevent carbon/dirt
from entering cylinder.
3. Remove screen holder (C), gasket (D) and screen (E) from muffler
body.
4. Clean carbon deposits from screen and muffler components.
5. Replace screen if it is cracked, plugged or has holes burned
through.
C
D
E
B
To Next Page
Loading...
Need help?
General
