19
9.5. Trouble Shooting and Remedy
In case of errors/troubles not mentioned above, please contact your local service technician for further assis-
tance.
9.6. Service address
Please see the back cover of this manual
Symptoms Possible Causes Remedy
The unit does not start • Is there voltage to the unit
• Fuse blown
• Display lights up, but the unit
does not start after reconnect-
ing voltage
• Unit starts after changing
startup method
• After reactivating flow start
• Reconnect voltage
• Call technician
• Go to setup -> Settings menu
-> Startup method,
and set it to pressure
• Set unit back to flow start in
setup menu
• Try to re-adjust flow switch
flashing
• Error messages on display
• Error after restart
• Press "0" wait for a few sec-
onds and then press "1"on
the control panel to restart the
system.
• Go to software manual
No pressure/too low pressure • Insufficient or No water supply
• Is the filter if any clogged
• Is the pump leaking or making
jarring sounds
• Rinsing nozzle not installed
• Open water supply valve
• Clean the filter
• Call technician
• Place rinsing nozzle
To Next Page
Loading...
Need help?
General
