Charge Your Marine FX speakers
Before you power on your Marine FX speakers,
connect the USB-C port to the USB cable and a 5V
power source to fully charge your Marine FX speakers
for best performance.
NOTE: Before using your Marine FX speakers for the first
time, charge the unit until all battery level indicators are
green, indicating a full charge.
Approximately 6 hours of charging is required from a low
to a full charge.
Power source options include the USB connection to
your computer or a power outlet using a 5V, 2A USB to
AC power adapter. It is recommended to always use the
USB cable and power adapter included with your Marine
FX speakers.
Power On, Battery, & LED Status Indicators
Once fully charged, press the Standby Power Button
on the top of your Marine FX speakers. You will see
the green LED light & you will hear, “Speaker on” when
powering on.
IMPORTANT: Make sure that the Main Power Switch,
located in the back compartment under the cap, is set in
the ON position. If the switch is in the OFF position, your
Marine FX speakers will not be able to turn on using the
Standby Power Button.
The LED battery level indicators are located on the top of
the unit. Each bar represents 25% of a charge, with 4 full
LEDs indicating a full charge.
Audio playback time over Bluetooth connection is
approximately 10 hours at 75% volume.
Set Up Recommendations 1-2-3
1
2
To Next Page
Loading...
Need help?
General