36
Using BIOS
Restore on AC Power Loss (Last State)
This item defines how the system will act after AC power loss during system operation. When you
set to Off, it will keep the system in Off state until the power button is pressed.
Resume On Ring (Disabled)
The system can be turned off with a software command. If you enable this item, the system can
automatically resume if there is an incoming call on the Modem. You must use an ATX power supply
in order to use this feature.
Resume On PME# (Enabled)
The system can be turned off with a software command. If you enable this item, the system can
automatically resume if there is an incoming call on the PCI Modem or PCI LAN card. You must use
an ATX power supply in order to use this feature. Use this item to do wake-up action if inserting the
PCI card.
USB Device Wakeup From S3 (Disabled)
This item allows you to enable/disable the USB device Wakeup function from S3 mode.
Resume On RTC Alarm (Disabled)
The system can be turned off with a software command. If you enable this item, the
system can automatically resume at a fixed time based on the system’s RTC
(realtime clock). Use the items below this one to set the date and time of the wake-up
alarm. You must use an ATX power supply in order to use this feature.
Press <Esc> to return to the main menu setting page.
Suspend Time Out (Disabled)
This sets the timeout for Suspend mode in minutes. If the time selected passes without any system
activity, the computer will enter power-saving Suspend mode.
Power Button Mode (On/Off)
This item lets you install a software power down controlled by the normal power button on your
system.
To Next Page
Loading...
Need help?
General
