62
A75F2-M2 USER MANUAL
Chapter 5
Figure 1.10 Windows Setup—Specify Devices
Installing the RAID Drivers
Your system may come with a Windows install CD that already includes AMD RAID
drivers. If so, then this section is not relevant.
If that is not the case (or you are trying to install a new version of Windows), then you
will need an AMD RAID driver F6 install floppy. Check to see if one came with your
system. If not, you can create one by downloading the appropriate driver package
and following the steps in this section.
Figure 1.9
Press F6 if you need to install a third party SCSI or RAID driver...
S=Specify Additional Devices ENTER=Continue F3=Exit
Windows Setup
Setup could not determine the type of one or more mass storage devices.
installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage device(s).
<none>
* To specify additional SCSI adapters, CD-ROM drivers, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storag device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
Windows Setup
---------
1. Copy all files in "...\RAID\ATI\A75\Floppy\Win3264" to a floppy disk.
2. After you complete the RAID BIOS setup, boot from the Windows CD.
The Windows Setup program starts.
3. Press F6 and wait a few moments for the Windows Setup screen to
appear.
4. Specify the AMD drivers.
To Next Page
Loading...
Need help?
General
