43
Using BIOS
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
ACPI XSDT Table (Disabled)
This item enables or disables the ACPI XSDT (Extended System Description
Table) Table.
Resume Event Control (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Phoenix-Award WorkstationBIOS CMOS Setup Utility
Resume Event Control
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
Item Help
Menu Level
Resume By Ring [Enabled]
Resume By PCI PME [Enabled]
Resume By PCI-E PME [Enabled]
Resume By USB (S3) [Enabled]
Resume By WOL [Disabled]
Resume By PS2 MS (S3) [Disabled]
Resume By PS2 KB (S3) [Password]
Hot Key Power ON Ctrl-F1
Power After PWR-Fail [Off]
RTC Alarm Resume [Disabled]
Date (of Month) 0
Resume Time (hh:mm:ss) 0:0:0
x
x
x
Resume By Ring (Disabled)
An input signal on the serial Ring Indicator (RI) line (in other words, an incoming call
on the modem) awakens the system from a soft off state.
Resume By PCI PME (Enabled)
This item specifies whether the system will be awakened from power saving modes
when activity or input signal of the specified hardware peripheral or component is
detected.
Resume By USB(S3) (Disabled)
This item allows you to enable or disable the USB device Wakeup function from S3
mode.
Resume By PCI-E PME (Enabled)
This item specifies whether the system will be awakened from power saving modes
when activity or input signal of the specified hardware peripheral or component is
detected.
Resume By WOL (Disabled)
This item specifies whether the system will be awakened from power saving modes
when activity or input signal of the specified WOL device is detected.
Soft-Off by PWRBTN (Instant Off)
Under ACPI (Advanced Configuration and Power management Interface) you can
create a software power down. In a software power down, the system can be resumed
by Wake Up Alarms. This item lets you install a software power down that is con-
trolled by the power button on your system. If the item is set to Instant-Off, then the
power button causes a software power down. If the item is set to Delay 4 Sec. Then
you have to hold the power button down for four seconds to cause a software power
down.
To Next Page
Loading...
Need help?
General
