45
Using BIOS
PC Health Status
On motherboards that support hardware monitoring, this item lets you monitor
the parameters for critical voltages, temperatures and fan speeds.
Phoenix-Award WorkstationBIOS CMOS Setup Utility
PC Health Status
SMART Fan Function [Press Enter]
Shutdown Temperature [80°C/176°C]
Warning Temperature [75°C/167°C]
CPU Vcore 1.39V
VDIMM 1.77V
CPU Tcontrol 30°C
System Temperature 40°C
CPU FAN Speed 3110 RPM
System Fan Speed 0 RPM
Item Help
Menu Level
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
Smart Fan Function (Press Enter)
Phoenix-Award WorkstationBIOS CMOS Setup Utility
Smart Fan Function
Scroll to this item and press <Enter> to view the following screen:
Smart Fan Control [Auto]
FAN1 START PWM VALUE 63
FAN1 START Temp °C 60
FAN1 Slope Select PWM/°C 2
Item Help
Menu Level
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
x
x
x
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
PCI/VGA Palette Snoop (Disabled)
This item is designed to overcome problems that can be caused by some nonstandard
VGA cards. This board includes a built-in VGA system that does not require palette
snooping so you must leave this item disabled.
Assign IRQ For USB (Enabled)
Names the interrupt request (IRQ) line assigned to the USB on your system.
If you cannot get a legacy ISA (Industry Standard Architecture) expansion card to
work properly, you might be able to solve the problem by changing this item to
Manual, and then opening up the IRQ Resources submenu.
• IRQ Resources (Press Enter): In the IRQ Resources submenu, if
you assign an IRQ to Legacy ISA, then that Interrupt Request Line is
reserved for a legacy ISA expansion card. Press <Esc> to close the
IRQ Resources submenu.
To Next Page
Loading...
Need help?
General
