© Edwards Limited 2011. All rights reserved. Page 3
Edwards and the Edwards logo are trademarks of Edwards Limited.
Unpack and inspect
A653-01-840 Issue F
2 Unpack and inspect
Remove all the packing materials and protective covers and check the components of the kit.
If any component is damaged, notify your supplier and the carrier in writing within three days; state the Item Number
of the kit together with your order number and the supplier’s invoice number. Retain the packing materials for
inspection. Do not use the kit if it is damaged.
Check that your kit contains the components listed in Table 1. Note that, except for the cartridge, the kit
components are packed in three separate bags, labelled bag 1, 2 and 3; the contents of the bags are shown in Table 1.
If any component is missing, notify your supplier in writing within three days.
If the kit is not to be used immediately, replace the protective covers and repack the components of the kit in the
packing materials. Store the kit in cool, dry conditions until it is required for use.
Table 1 - Checklist of cartridge kit components
Bag label Qty Description
Figure 1-3
reference
Check (9)
- 1 Cartridge A
1 Gas ballast check-valve 210
2 Spring (valve and gas ballast check-valve) 211
1 Printed gasket (cartridge) 215
Bag 1 1 Dump valve 217
1Oil pressure valve 209
1 O-ring: 57.6 x 2.4, viton (cartridge/adaptor) 127
1 Coupling element 411
1 Inlet-valve ‘U’ seal 202-5
1 O-ring: 49.5 x 3.0, nitrile (inlet-valve) 202-6
Bag 2 1 O-ring: 7.6 x 2.4, viton (inlet-valve) 202-7
1 O-ring: 32.5 x 3.0, nitrile (inlet-valve) 202-8
1 Spring (inlet-valve) 213
1 Printed gasket (top-plate) 216
1 O-ring: 42.5 x 3.0, nitrile (inlet connection)
*
*
If required.
005
1 O-ring: 14.6 x 2.4, nitrile (gas ballast control) 203-3
1 O-ring: 21.5 x 3.0, nitrile (gas ballast control) 203-4
1 O-ring: 9.6 x 2.4, viton (mode selector) 204-3
1 Spring (gas ballast control) 212
Bag 3 3 O-rings: 21.5 x 3.0, nitrile
(gas ballast insert
*
and mode selector)
220
1Shoulder washer 222
1 Exhaust diaphragm 301-3
1 Printed gasket (oil-box) 314
3 O-rings: 28.2 x 3.53, nitrile
(oil filler-plugs and exhaust-flange)
319
1 O-ring: 69.5 x 3.0, nitrile (sight-glass) 321
1 O-ring: 15.6 x 2.4, nitrile (oil drain-plug) 323
To Next Page
Loading...
Need help?
General
