EasyManuals Logo
Home>Edwards>Water Pump>RV3

Edwards RV3 Service Manual

Edwards RV3
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
© Edwards Limited 2018. All rights reserved. Page 3
Edwards and the Edwards logo are trademarks of Edwards Limited.
Parts list
A652-01-840 Issue P
2 Parts list
Exploded views of a generic RV pump are shown in Figure 1 to 4. The component parts shown on the figures are listed
in Table 1. When you read Table 1, take note of the following:
Where a G.A. Item is in the form 'XXX-Y', this specifies that the part is a component of a sub-assembly (that
is, the inlet valve, exhaust flange or ballast knob sub-assemblies). In these cases, XXX specifies the sub-
assembly (and may be shown on Figure 1) and Y specifies the specific component of the sub-assembly.
The entries in the 'Kit No.(s)' column are cross references to the kits in Table 2. If a part has an entry in this
column, then the component part is included in the referenced maintenance kit(s).
If a part has an entry in the 'Part No.' column, then the part is available as a spare and the entry defines the
Item Number of the spare part.

Other manuals for Edwards RV3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edwards RV3 and is the answer not in the manual?

Edwards RV3 Specifications

General IconGeneral
BrandEdwards
ModelRV3
CategoryWater Pump
LanguageEnglish

Related product manuals