23
Trigger
Parameters for HH pedal
HH Pedal Selects the HH pedal model
Foot Close
Sens
Adjusts sensitivity of the foot-close and foot-
splash of the hi-hat pedal.
The default value is 0.
Closed HH
Tightness
Adjusts the closed hi-hat sound tightness at
the closed pedal position.
When set toward +, tight closed hi-hat is
sounded even if the pedal is pressed lightly.
The default value is 0.
With this settings, you can cancel cross-talk which
means that when you hit a pad, you also hear sounds
coming from other pads, due to the vibration travel.
This phenomenon can often happen when the two
pads are mounted on the same stand.
Parameters for each pad
Source Pad Selects the source pad of the vibration
Other pads
Example:
In case that you hear a Tom 3 sound when
you strike the snare pad, select the snare as
source pad, and increase the value of the Tom
3 until the Tom 3 no longer sounds.
* Note not to set too high value.
Reset Resets values for all pads.
HH CTRL
X-TALK ELIM.
HH pedal
position
To Next Page
Loading...
Need help?
General
