56V LITHIUM-ION CORDLESS 20" CHAIN SAW — CS2000/CS2000-FC 25
OPERATION
WARNING:
Do not allow familiarity with this product to make you careless.
Remember that a careless fraction of a second is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side shield
marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown
into your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not recommended by the
manufacturer of this product. The use of attachments or accessories not recommended
can result in serious personal injury.
Before each use, inspect the entire product for damaged, missing, or loose parts such
as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts are replaced.
APPLICATIONS
You may use this product for basic felling, limbing, pruning, and woodcutting of lumber
and trees.
FILLING OIL TANK WITH BAR AND CHAIN LUBRICANT
WARNING:
To prevent accidental starting that could cause serious personal injury,
always remove the battery pack from the chain saw before filling the tank with oil.
WARNING:
Do not smoke or bring any fire or flame near the oil or the chain saw.
Oil may spill and cause a fire.
NOTICE: The chain saw is not filled with
oil at the time of purchase. It is essential
to fill the tank with chain oil before use.
Operating the chain saw without chain
oil or when the oil level is below the
minimum mark will result in damage to the
chain saw. Chain life and cutting capacity
depend on optimum lubrication. The chain
is automatically lubricated with chain oil
during operation, if there is sufficient oil in
the oil tank.
9
Oil Tank Cap
Tab
Minimum Oil Mark
To Next Page
Loading...
Need help?
General
