EINHELL GC-BC 25 AS Operating Instructions

GB
- 27 -
far away from possible ignition sources such as
an oven, a gas-fi red hot water boiler, a gas-fi red
dryer, etc.
Putting the equipment back into operation
1. Remove the spark plug (see section 9.4).
2. Clean the spark plug and check that the
electrode gap is correct, or insert a new spark
plug with the correct electrode gap.
3. Prepare the equipment for operation.
4. Fill the tank with the relevant mixture of fuel
and oil. See the section „Fuel and oil“.
10.3 Transport
To transport the machine, empty the petrol tank
as described in section 10. Clean coarse dirt off
the equipment with a brush or hand brush. Dis-
mantle the drive rod mechanism as described in
section 5.1.2.
10.4 Ordering spare parts
Please provide the following information on all
orders for spare parts:
•
Model/type of the equipment
•
Article number of the equipment
•
ID number of the equipment
•
Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
11. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Defective components must be dispo-
sed of as special waste. Ask your dealer or your
local council.
Anl_GC_BC_25_30_AS_SPK1.indb 27Anl_GC_BC_25_30_AS_SPK1.indb 27 21.10.2016 11:59:2921.10.2016 11:59:29

EINHELL GC-BC 25 AS Specifications

General

Product color	Aluminium, Black, Red
Rotational speed	7200 RPM
Number of strokes	2
Fuel tank capacity	0.4 L
Engine displacement	27 cm³
Automatic feed spool	Yes
Cutting diameter (max)	450 mm
Power source	Gasoline

Weight and Dimensions

Weight	6300 g
Package depth	1000 mm
Package width	260 mm
Package height	250 mm
Package weight	8300 g