EasyManuals Logo
Home>EINHELL>Lawn Mower>GC-PM 40 S

EINHELL GC-PM 40 S User Manual

EINHELL GC-PM 40 S
Go to English
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
GB
- 28 -
9. Troubleshooting guide
Warning: Switch o the engine and pull out the spark plug boot before making any checks or adjust-
ments.
Warning: If, after making an adjustment or repair to the engine, you let it run for a few minutes, remem-
ber that the exhaust and other parts will get hot. Do not touch these parts as they may burn you.
Fault Possible cause Remedy
The equipment
does not operate
smoothly and vibra-
tes intensively
- Bolts loose
- Blade attachment is loose
- Blade imbalanced
- Check bolts
- Check blade attachment
- Replace blade
The engine does
not start
- Engine start/stop lever is not
pressed
- Throttle lever in wrong position (if
provided)
- Spark plug defective
- Fuel tank empty
- Fuel pump (primer) not actuated (if
provided)
- Press the engine start/stop lever
- Check setting (if provided)
- Replace spark plug
- Top up fuel
- Actuate the fuel pump (primer) (if
provided)
Engine does not run
smoothly
- Air lter dirty
- Spark plug dirty
- Clean the air lter
- Clean the spark plug
Lawn turns yellow,
uneven cut
- Blade is not sharp
- Cutting height too small
- Engine speed too low
- Sharpen blade
- Adjust to the proper height
- Set the throttle lever to max. (if pro-
vided)
Grass chute is not
clean
- Engine speed too low
- Cutting height too small
- Blade is worn
- Grass bag is clogged
- Set the throttle lever to max.
- Set properly
- Replace the blade
- Empty the grass bag
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
Anl_GC_PM_40_S_SPK7.indb 28Anl_GC_PM_40_S_SPK7.indb 28 18.10.2018 14:05:4518.10.2018 14:05:45

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EINHELL GC-PM 40 S and is the answer not in the manual?

EINHELL GC-PM 40 S Specifications

General IconGeneral
TypeWalk behind lawn mower
Drive typeRear wheel drive
Motor typeSingle cylinder OHV
Cooling typeAir
Cutting width400 mm
Grass catcherYes
Product colorBlack, Grey, Red
Cutting systemRotary blades
Number of wheels4 wheel(s)
Rotational speed2900 RPM
Maximum lawn area1000 m²
Mulching function-
Fuel tank capacity1 L
Handle(s) featuresErgonomic, Foldable
Engine displacement99 cm³
Rear wheels diameter203 mm
Front wheels diameter178 mm
Maximum cutting height60 mm
Minimum cutting height25 mm
Grass collecting volume45 L
Engine number of strokes4
Number of height positions7
Power sourceGasoline
Weight and Dimensions IconWeight and Dimensions
Depth710 mm
Width533 mm
Height415 mm
Weight21400 g
Package weight24400 g

Related product manuals