OPERATING
INSTRUCTIONS
The fans are only to be operated within the ranges specified on the motor name-plate
or in the technical specification released by Technical Dept.
Do not make any modification, additions or conversation to the device without the
approval from Regal Beloit Italy.
The unit complies with the applicable standard and regulation and meets the
requirements of the Low Voltage Directive 2014/35//EU and EMC guideline
2014/30/EU.
The unit meets the following standards:
EN 60529 Degree of Protection provided by
enclose (IP code)
EN 55014-1&2 + EN 61000 Electromagnetic
Compatibility
Safety of household and similar appliances (see
the Declaration of conformity)
Stand on a rubber mat if you are working on an electrically charged device
Wait one minute after disconnecting the voltage before opening the device
Do not touch the fan blade once it is installed
When motor is powered on, it has to run after few. If not, switch off and switch on
again to re-start. Always waiting few seconds to verify the functionality. In case the
motor doesn’t move, replace it.
Secure the device against accidental contact and make sure, when device stop, to wait
until fan blade is completely stopped before working on the machine
Check fan blade fixing screw, it must not be loose.
Appliance must be use in permitted ambient temperature, see technical data
To Next Page
Loading...
General