Installation
20
5 Fit the (A) screws in the desired set of holes
for 85, 88 or 90 cm worktop height (
SEE
ILLU
-
STRATION
A).
6 Lift the cooker back into the upright position
and connect it to the electrical supply. Push the
cooker
into place and adjust its level (see below)
before fitting the safety equipment.
Levelling the cooker
The cooker must be level, for example to ensure that oil
in frying pans is of even depth. To check whether the
cooker is level, place a spirit level or a frying pan filled
with water on the hob.
You can lower (-6 mm) or raise (+12 mm) the
wheels and feet, working from the front of the cooker.
Use a Phillips screwdriver to adjust the rear wheels,
and adjustable pliers for the front feet (1). Once the
cooker is properly level, you need to lock these feet
with the nut. Turn it anticlockwise (2) using the
spanner supplied.
Electrical connection
Repairs and work on the cooker must be carried
out by a
QUALIFIED
ELECTRICIAN
. Work performed
by unqualified persons can damage the cooker,
and may also lead to personal injury and/or
damage to property.
The connection options for the cooker are shown on
the plate on the rear of the cooker. Wattage and voltage
is stated on the rating plate (see the right-hand side of
the cooker).
1
2
To Next Page
Loading...
Need help?
General
