35
Connecting the Dishwasher
Water Connection
The dishwasher is fitted with safety devices that pre-
vent the wash water returning into the drinking water
system and comply with the applicable plumbing reg-
ulations.
• The dishwasher can be connected to cold and hot
water supplies up to max. 60 °C.
• The dishwasher must not be connected to open
hot water appliances or instantaneous water heat-
ers.
Permitted water pressure
Connect the inlet hose
1
The water inlet hose must not be kinked,
crushed or entangled when it is being con-
nected up.
Connect the threaded hose fitting
(ISO 228-1:2000) on the water inlet hose to a
tap with an external thread (¾ inch). Tighten
the threaded hose fitting hand tight only.
3
In order that access to the tap in the kitchen
is not limited by the use of the dishwasher,
we recommend the installation of an addi-
tional tap, or fitting a two way adapter to the
existing tap.
• If you need a longer water inlet hose than that
supplied, VDE approved complete hose sets are
to be used. These are available from your local
Service Force Centre.
Lowest permitted water pressure:
1 bar (=10 N/cm
2
=100 kPa)
Consult your installer if the water pressure is less than 1 bar.
Highest permitted water pressure:
10 bar (=100 N/cm
2
=1 MPa)
In the case of a water pressure greater than 10 bar, a pressure reduc-
tion valve must be used (available from your dealer).
To Next Page
Loading...
Need help?
General
