Problem Possible cause Possible solution
You did not remove the pack-
aging and/or the transit bolts.
Remove the packaging and/or the trans-
it bolts. Refer to 'Installation'.
The load is very small. Add more laundry in the drum.
The appliance fills with
water and drain imme-
diately.
The end of the drain hose is
too low.
Make sure that the drain hose is in the
correct position. Refer to 'Installation'.
The washing results
are not satisfactory.
The detergent you used was
not sufficient or correct.
Increase the detergent quantity or use a
different one.
You did not remove the stub-
born stains before you wash
the laundry.
Use special products to remove the
stubborn stains.
Incorrect temperature was set. Make sure that you set the correct tem-
perature.
Too much laundry load. Decrease the laundry load.
After the check, activate the appliance. The programme continues from the point of inter-
ruption.
If the problem occurs again, contact the service centre.
Service
Refer to the information supplied with this
appliance for guarantee condition and point
of contact. The information to give to the
service is on the rating plate.
We recommend that you write the
information here:
Model ..................
Product number 914.............
Serial number
(S.N.)
..................
INSTALLATION
Unpacking
1. Use the gloves. With a scissor cut the
straps and with a cutter remove the ex-
ternal film.
Do not to discard the plastic cover (A).
1
2
A
2. Remove the polystyrene packaging
materials.
16 electrolux
To Next Page
Loading...
Need help?
General
