24
Using your steam mop
Fig 5
Fig 6
Fig 3
Fig 4
Fig 1
Fig 2
The Electrolux steam mop is designed for use on hard-surface floors such as ceramic, stone, marble, vinyl, linoleum,
and sealed hardwood. Do not use on unsealed wood floors. If uncertain, test in an isolated area such as a closet.
NOTE: Heat and steam may remove the sheen on waxed floors or on some no-wax floors. Check use and care
instructions from flooring manufacturer.
C A U T I O N
!
Be sure steam mop is turned off and unplugged
before removing water tank.
!
Fill tank with clear water only. Do not use
chemicals, soap or detergent.
!
Never use steam mop without cleaning pad.
!
Always direct steam away from yourself. Never
direct steam toward people, animals, or plants.
!
Sweep or vacuum floor before using steam mop.
!
Press release button and lift off water tank (Fig.1).
!
Remove cap and fill tank with clean tap water. Do
not exceed maximum fill line (Fig. 2). In areas with
hard water, use distilled water for better
performance.
!
Put water tank back in place.
!
Place cleaning pad on floor with Velcro loop strips
facing up. Set floor nozzle onto pad (Fig. 3).
!
Turn knob to adjust steam output for type of floor
(Fig. 4). See page 5.
!
Press down front of clean burst pedal to ‘floor
mop’ position (Fig. 5).
!
Plug in and turn power switch to ‘on.’
!
Hold down floor nozzle and pull handle back to
comfortable angle for mopping (Fig. 6).
Do not leave steam mop standing on the
floor for any length of time while damp
cleaning pad is still on it. If you notice a whitish
‘halo’ on the floor surface, it can be removed
with a few drops of vinegar.
To Next Page
Loading...
Need help?
General
