Elitech ECS-2180neo User Manual

Note ① only applicable when sensor is functional
Note ② Caution required when changing from Celsius Fahrenheit as all
parameters will change accordingly.
ALARM CODES
SPECIFICATION
Front panel 34.5 (H) x 76mm (W) +/- 2mm
Cut out 30 (H) x 72mm (W) +/- 1mm
Operating temperature -5 to 55°C
Storage temperature -10 to 65°C
Power supply 12/24 Volt DC
Power consumption < 10 watts
Temperature range -40 to 90°C
Inputs = 2 NTC sensors 1.5m
Outputs:
 Compressor output 17/7Amp
 Fan output 10 Amp
 Defrost output 10 Amp
 Alarm output = built in buzzer
Problem solver
 Remove power from controller

E1 or E2 check probe connections, clean plug in terminals

Probes can be extended to 100m but should have good
watertight connections, recalibration may be required for long
extension

LA alarm = excessive temperature, allow controller to cool
down and relocate or ventilate to keep cool

Relay failure = check full load amperage of output to ensure
that it is below ratings on controller

Defrost will not start = check coil temperature

Fan will not start = check coil temperature
Wiring
Warranty procedure
1 year replacement warranty
Return controller to supplier complete with
probes
Give detailed description of fault and
equipment

Elitech ECS-2180neo Specifications

Operating Environment

operating temperature	-5 to 55°C
storage temperature	-10 to 65°C
temperature range	-40 to 90°C

Power

power supply	12/24 Volt DC
power consumption	< 10 watts

Outputs

compressor output current	17/7 Amp
fan output current	10 Amp
defrost output current	10 Amp

Weight and Dimensions

front panel dimensions	34.5 (H) x 76mm (W) +/- 2mm
cut out dimensions	30 (H) x 72mm (W) +/- 1mm