1
3
2
2
Power Cord Video CableUSB Cable Serial Cable
1
3
2
Power Cord Video CableUSB Cable
For APR model only
Touch Interface Connection
Note: Before connecting the cables to your touchmonitor and PC, be sure that the computer and
touchmonitor are turned off.
DC JACK
DC JACK
1. Connect one end of the power cord to the monitor and the other end to the AC outlet.
2. Connect one end of either the touchscreen serial(RS232) cable or the touch screen USB cable
(but not both) to the rear side of the computer and the other end to the LCD monitor. Tighten by
turning the two thumb screws clockwise to ensure proper grounding(optional module USB cable
does not have thumb screws)
3. Connect one end of the video cable to the rear side of computer and the other to the LCD monitor.
Tighten by turning the two thumb screws clockwise to ensure proper grounding.
4. Press the power button on the front panel to turn the monitor power on.
Magnetic Stripe Reader(MSR) Interface Connection(optional)
If the MSR is installed on the monitor, plug the USB cable from the MSR directly to the PC.
No drivers are required to be loaded.
To change the MSR function mode from keyboard emulation to HID, load the “MSR CHANGE
MODE.EXE” utility from the enclosed TouchTools CD or go online to www.elotouch.com to
download this utility.
Note: MSR function mode can be changed to HID mode from keyboard emulation mode and back
using the “MSR CHANGE MODE.EXE” utility.
2-10 User Guide
To Next Page
Loading...
Need help?
General
