Emax TINYHAWK III User Manual

1. With the E8 Transmitter turned off, press the "L3-" button and the power button at the
same time as the controller turns on.
2. Wait for the center indicator to light up and change from fast flashing to slow flashing,
and push the joysticks of E8 Transmitter to the maximum travel in the four directions up,
down, left, and right.
3. Press the "L3-" button, the prompt will sound, exit the calibration mode, and the E8
Transmitter will then boot up.
1.7 Changing Transmitter Modes
Remove the screw and open the back cover of the E8 Transmitter housing. There is a
toggle switch on the left side of the board. Set the toggle switch to "L" (left-hand throttle
mode) or "R" (right-hand throttle mode), and swap the positions of the levers (the 6Pin
cable connecting the joystick to the main board does not need to change positions).
Left-handed mode: E8 Transmitter left stick, controls the throttle and yaw direction of
Tinyhawk III; E8 Transmitter right stick, controls Tinyhawk III's pitch and roll.
Right-handed mode: E8 Transmitter left stick controls the pitch and roll of Tinyhawk III; E8
Transmitter right stick controls the throttle and yaw direction of Tinyhawk III.
Schematic diagram of the left and right-handed joysticks (the picture shows the left-
handed mode, and of the joystick control reversed in the right-handed mode)

Emax TINYHAWK III Specifications

General

Brand	Emax
Model	TINYHAWK III
Category	Quadcopters
Language	English