1.2 Power on & off
Press and hold the power button while the center indicator light turns on red. After 2
seconds, the center indicator light turns from red to green, and it powers on.
Press and hold the power button, after 2S, the center indicator will go out, and it will
shutdown.
1.3 Binding & Unbinding
The E8 Transmitter has been bound with Tinyhawk III in the RTF kit. If it is necessary to
bind, please follow the steps below:
1.
Enabling Bind Mode: Turn on the power and after the Tinyhawk III starts, press and hold
the bind button to make the Tinyhawk III enter Bind Mode. When the blue indicator light
of the Tinyhawk III flight controller flashes, this is indicating that it has entered Bind Mode.
2.
E8 Transmitter enters binding mode: first turn on the E8 Transmitter, then press the
"L4+" & "R3-" buttons at the same time, and hold down for 2S until the center indicator
turns from green to red, and the center indicator turns to green Flashes alternately with
red, indicating that the remote control has entered the binding mode.
3.
Check that when the blue light on the Tinyhawk III flight control board changes from
steady light to flashing, it means that the binding has been completed. Then press the
"L4+" & "R3-" buttons on the E8 Transmitter at the same time again, and the blue light
flashes again Turns to steady light, indicating that the binding has been completed.
4.
Unbinding: Unplug the battery of Tinyhawk III to power off and leave Bind Mode.
1.4 Mode switching
D8 mode: press the power switch and the "L1+" button at the same time: turn on and enter
D8 mode, then the mode indicator will turn solid red.(Emax recommends D8 mode)
D16 mode: press the power switch and the "L2-" button at the same time: turn on and
enter D16 mode, then the mode indicator light will turn solid green.
D16 LBT mode: Press the power switch and the "L4+" button at the same time: Turn on the
controller and enter D16 LBT mode, then the mode indicator light will turn solid yellow.
1.5 Gimbal Trim
Each joystick has a corresponding Trim button. Each Trim button adjusts the direction of the
corresponding joystick control. Each time it is adjusted, a beep will sound. When it is
adjusted to the center position, it will make a longer beep. Please pay attention to the
sound. With joysticks centered, use the Trim buttons until the drone is steadily hovering in
place.
1.6 Calibration of joystick
The E8 Transmitter is pre-calibrated, but recalibration can help solve some common issues:
To Next Page
Loading...
Need help?
General
