8
ETL Model No.: CF235
3. Ceiling Fan Assembly (Continued)
MOTOR
COUPLER
LOOSEN SET
SCREWS (2)
DOWNROD
Figure 7
MOTOR
COUPLER
CLEVIS
PIN
HAIRPIN
CLIP
HAIRPIN
CLIP
CLEVIS
PIN
Figure 8
3.7
Loosen the Two Phillips Head Set Screws in the Motor
Coupler for installation of the 4.5” Downrod (Figure 7).
Seat the 4.5” Downrod in the Motor Coupler (Figure 7).
Rotate and align the 4.5” Downrod holes with the Two
Holes in the Motor Coupler (Figure 7).
3.8
Install the Clevis Pin and secure with the Hairpin Clip
(Figure 8).
The Clevis Pin must go through the Motor Coupler
Holes. It is critical that the Clevis Pin is properly
installed and secured with the Hairpin Clip.
It is critical that the clevis pin is properly installed and
secured with the hairpin clip. Failure to verify that the
pin is properly installed could result in the fan falling.
WARNING
!
To Next Page
Loading...
Need help?
General