EasyManuals Logo
Home>Emerson>LCD TV>LC320EM2F

Emerson LC320EM2F Service Manual

Emerson LC320EM2F
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
7-1 FL11.4FW
FIRMWARE RENEWAL MODE
Equipment Required
a. USB storage device
b. Remote Control Unit
Firmware Update Procedure
Note: There are two states (the User Upgrade and
the Factory Upgrade) in firmware update.
The identification of User Upgrade and Factory
Upgrade are done by the filename.
1. Turn the power off and unplug the AC Cord.
2. Insert the USB storage device to the USB port as
shown below.
3. Plug the AC cord in the wall outlet and turn the
power on.
4. The update will start and the following will appear
on the screen.
Note: If the above screen isn’t displayed, repeat from
step 1.
The appearance shown in *1 is described as follows.
5. When the firmware update is completed, the
following will appear on the screen.
Remove the USB storage device from the USB
port.
Turn the power off and turn the power on again.
Note:
When the Factory Upgrade is used, after
restarting TV, shift to initial screen menu in service
mode. "INITIALIZED" will appear on the upper
right of the screen. "INITIALIZED" color will
change to green from red when initializing is
completed.
User Upgrade Upgrade the firmware only.
The setting values are not
initialized.
Factory Upgrade
(Firmware
upgrade)
Upgrade the firmware and
initialize the setting values.
Factory Upgrade
(Flash upgrade)
Upgrade the firmware and
initialize the setting values
along with the setting data
adjusted at the factory such as
White Balance, etc.
Rear Cabinet
USB port
USB storage
device
Appearance State
Downloading...
Downloading the firmware from
the USB storage device.
Writing...
Writing the downloaded firmware
in flash memory.
Checking... Checking the new firmware.
Software upgrade in progress. Please wait.
Do not remove the USB storage device or
turn the TV off while upgrade is in progress.
Software Upgrade
Downloading...
Current Version:
New Version:
*******-***-*-***-****
*******-***-*-***-****
0%
*1
"
*
" differs depending on the models.
Software Upgrade
The software upgrade is completed.
Remove USB storage device, turn TV off then on again.

Other manuals for Emerson LC320EM2F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Emerson LC320EM2F and is the answer not in the manual?

Emerson LC320EM2F Specifications

General IconGeneral
BrandEmerson
ModelLC320EM2F
CategoryLCD TV
LanguageEnglish

Related product manuals