GFK-2573AB Jul 2022
8
Release History
Support for IC695CMM002 and IC695CMM004 MODBUS
master and slave serial communications to the RX3i
PROFINET scanners IC695PNS001-Bxxx, IC695PNS101, and
IC695CEP001
IC695PNC001-BEBD
IC695PNC001CA-
BEBD
IC695PNC001LT-
BEBD
The product's labels have been updated to show compliance
with new certifications.
For updated certifications, please refer to https://emerson-
mas.force.com/communities/en_US/Article/Certifications-
and-Agency-Approvals-Landing-Page.
Manufacturing update. No change to fit, form, or function.
Resolved a Loss of Device in an MRP Ring after the
PNC001-Bxxx is reset.
Rebranded the PNC001 to Emerson, applied patches for
VxWorks URGENT/11 vulnerabilities, and made additional
updates to enhance cyber security.
Resolves an issue sending COMMREQs to the IC695GCG001
Genius Communication Gateway if its PROFINET Device ID is
128 or greater.
Hardware change: slight housing dimension change to
address the issue of difficulty installing a module into a slot
with another module already installed in the left adjacent
slot.
Corrects these issues: PROFINET IO Not Scanned After Loss of
Both Critical Ring Ports, Addition of IO Module Causes IO
Device to Disconnect, and Bumpless IO Using Link Change
Detection May Fail Using a PNC001-Bxxx as an MRM. Also
includes updates to enhance cyber security.
Redesign hardware and firmware for component
obsolescence, reduce power requirements and comply with
EU RoHS.
Adds support for the Genius Communication Gateway’s
(GCG001) Switch BSM and Enable/Disable Outputs
COMMREQs.
Supports the Remote Get HART Device Information
COMMREQ. Information from a HART device connected to
an RX3i Analog Module in an IC695PNS001 RX3i PROFINET
Scanner may be read into the user application using the
Remote Get HART Device Information COMMREQ.
Supports extended PROFINET device Subslot Numbers to
support additional 3rd party devices. The maximum Subslot
Number has been increased from 255 to 21845.
To Next Page
Loading...
