General
Your Emerson Ceiling Fan/Light SR600
Remote Control consists of hand-held
transmitter and a receiver which is
mounted under the fan ceiling cover. The
remote control is designed to separately
control your ceiling fan speed and light
intensity.
The remote control transmitter is powered
by two AAA alkaline batteries (included).
To prevent possible damage if the
batteries should leak, be sure to remove
the batteries when the control is not to be
used for an extended period of time.
Code switches in the transmitter and
receiver may be set in 32 different
positions. If your fan and light go on and
off without using your control, you may be
getting interference from other remote
units such as garage door openers, car
alarms or security systems. To remedy this
situations, simply change the combination
code in your transmitter and receiver.
Preset Memory Feature
Your Emerson receiver is equipped with a
preset memory feature. If the AC supply to
the receiver is powered through a wall
switch, when the switch is turned OFF, the
control will remember the light intensity
and fan speed. When the switch is turned
back ON the light and fan will resume
operation as they were prior to the switch
being turned OFF.
3
General
Your Emerson Ceiling Fan/Light Control
may be used with a SR600 or SR650
Remote Control or a SW605 Wall Control.
The remote control or wall control is
designed to control your ceiling fan speed,
airflow direction, and light intensity.
Unpackaging
The carton with the SR650 Remote
Control contains a storage bracket with
two mounting screws.
The carton with the SW605 Wall Control
contains three switch covers; ivory, white
and almond color.
IMPORTANT
This Owner’s Manual is divided into three
sections. The first section: SR600
REMOTE CONTROL PROCEDURES,
describes how to install the two AAA
alkaline batteries in the SR600 remote
control transmitter and operating
fuctions. The second section: SR650
REMOTE CONTROL PROCEDURES
describes how to install the two CR2032
Lithium batteries in the SR650 remote
control transmitter and operating
fuctions. The third section describes how
to install the SW605 Wall Control. These
instructions must be performed prior to
installation of the ceiling fan as described
in the Ceiling Fan Owner’s Manual.
SR600 REMOTE
CONTROL PROCEDURES
To Next Page
Loading...
Need help?
General
