General
Your Emerson Ceiling Fan/Light SR650
Remote Control consists of hand-held
transmitter with wall mount and a receiver
which is mounted under the fan ceiling
cover. The remote control is designed to
separately control your ceiling fan speed
and light intensity.
The remote control transmitter is powered
by two CR2032 Lithium batteries
(included). Be sure to remove the batteries
when the control is not to be used for an
extended period of time.
SR650 REMOTE
CONTROL PROCEDURES
5
Figure 4
Installation of Storage
Bracket for SR650
Remote Control
A storage bracket is provided for holding
your remote control when not in use. If you
desire to use the bracket, install remote
control storatge bracket using the two
screws provided. Install on a wall that is
away from excess heat or humidity
(Figure 4).
Code switches in the transmitter and
receiver may be set in 32 different
positions. If your fan and light go on and
off without using your control, you may be
getting interference from other remote
units such as garage door openers, car
alarms or security systems. To remedy this
situations, simply change the combination
code in your transmitter and receiver.
Preset Memory Feature
Your Emerson receiver is equipped with a
preset memory feature. If the AC supply to
the receiver is powered through a wall
switch, when the switch is turned OFF, the
control will remember the light intensity
and fan speed. When the switch is turned
back ON the light and fan will resume
operation as they were prior to the switch
being turned OFF.
Installation of Battery
1. Remove the battery cover by pressing
firmly below the arrow and sliding the
cover off the control (Figure 3).
2. Install one CR2032 Lithium battery into
the battery compartment then stack the
other CR2032 Lithium battery on top of
the installed battery and reinstall the
battery cover.
To Next Page
Loading...
Need help?
General
