Entrust Sigma DS3 Installation And Administrator's Guide

Sigma DS1, DS2, and DS3 Card Printers Installation and Administrator’s Guide 21
Set the Printer Network IP Address
You need the printer IP address to perform some tasks. For example, the XPS Card Printer Driver
asks you to enter the network IP address during installation. You also can launch the Printer
Dashboard by entering the printer IP address in a browser window.
To display either a USB or network IP address, you can do one of the following:
 Press the up or down arrow key on the front panel while the printer displays Ready.
 Use the LCD menu system Status menu. Refer to the printer’s User’s Guide for more
information about using the Status menu to display the IP address.
The card printers support both IPv4 and IPv6 addressing. If your network environment uses IPv6
you can use the LCD Configuration menu to enable the IPv6 settings that manage the printer
communication over an Ethernet network. You do not need to make any configuration changes to
use IPv4.
Use IPv4 Addressing
When you use IPv4, the printer can use either of the following network communication methods:
 DHCP (Dynamic Host Configuration Protocol)—The network automatically assigns the IP
address to the printer. The IP address of a printer that uses DHCP can change if the printer is
powered off and back on.
 Static IP—You set the IP address, subnet mask, and gateway address, as provided by your
network support personnel. A static IP address does not change when the printer is powered
off. Some sites may require that the printer has the same IP address at all times. Refer to “Set
a Static IPv4 Address” on page 22.
You also can use the Printer Dashboard to change the communication method and
define printer address information. Refer to the Printer Dashboard Help for complete
information.

Entrust Sigma DS3 Specifications

General

Print Resolution	300 dpi
Card Capacity Input Hopper	100 cards
Card Capacity Output Hopper	25 cards
Power Supply	100-240 VAC, 50/60 Hz
Print Technology	Dye sublimation
Print Capabilities	Single or dual-sided
Card Thickness	0.010 inches to 0.040 inches
Supported Card Sizes	CR80 (85.6 mm x 54 mm)
Connectivity	USB and Ethernet
Operating System Support	Windows 7, 8, 10, Server 2008, 2012, 2016
Weight	5.49 kg (12.1 lbs)
Operating Temperature	15°C to 35°C (60°F to 95°F)
Operating Humidity	20% to 80% (non-condensing)
Print Speed	Up to 250 cards per hour (YMCKT)